Reasons people replace a toilet
- A cracked bowl or tank
- An old high-volume toilet using far more water than modern models
- A bathroom renovation or a new basement washroom
- A toilet that clogs often because of poor bowl design
What a good installation includes
The old toilet comes out first, and a plug goes in the drain so sewer gas stays put. The flange is checked for height and damage; a broken or low flange is repaired, because it is the most common reason new toilets leak. The new toilet is set on a fresh seal, bolted evenly, hooked up with a fresh braided connector, plus a new stop valve if the old one is tired.
- Remove and dispose of the old toilet.
- Inspect and repair the flange and subfloor.
- Set the new toilet with a fresh seal and new bolts.
- Connect the supply, adjust the fill level and test.
Choosing a model
Look for a WaterSense or similar efficiency label, a flush rating suitable for real use, and a rough-in that matches your drain, which is usually 12 inches from the wall in Brampton homes. Comfort-height bowls suit many adults; standard height is better for small children. Elongated bowls need more room in front.
Tools, access and testing
| Tools we bring | Basin wrench, closet auger, cartridge pullers, wax rings |
|---|---|
| What we open | Toilet base, vanity cabinet, shower trim and valve body |
| What we test | Seal at the flange, fill and flush cycles, drips at shut-offs |
Where in Brampton we do this
We take toilet installation calls right across the city, including Bram East, Mount Pleasant, Credit Valley, Peel Village and the streets around them.
Questions we get
Will you fit a toilet I picked up at the store?
Happily. Measure your rough-in first, and confirm the tank, bowl and seat are all in the box.
How much time should I set aside?
Plan on part of a morning; a damaged flange or soft subfloor adds time.